The high solids, all-weather, deep penetrating anti-corrosive primer What is it? Penetrol CIP is a highly effective bright red/brown primer for rusted surfaces with the outstanding penetrating properties of Penetrol ... better than water. It makes a secure base on hand-cleaned steel for any type of paint including 2-part Epoxy, Urethane, Vinyl, Chorinated Rubber and conventional finishes. Granular or tightly bonded rust need not be removed. High in solids, Penetrol CIP is economical an excellent all weather and general maintenance primer for all metals. What does it do? Penetrol CIP penetrates deeply into the metal surface and bonds granular rust into a tough, protective coating. Unlike conventional primers, Penetrol CIP does not 'bridge' over the many imperfections present on any steel surface, but fills every pinhole, driving out air and moisture ... the 'food' rust needs to grow. Penetrol CIP has excellent resistance to water immersion and condensation and helps in descaling heavy rust deposits. It is highly flexible, will not flake, crack or peel and does not need sanding prior to top-coating. Where to use it? Use Penetrol CIP on all rusted and corroded surfaces where a tough flexible primer is needed under all types of conventional and synthetic coatings. It performs well even when difficult drying conditions exist such as in relative high humidity or low temperatures. Penetrol CIP prepares rusted surfaces for painting: · STOPS RUST ON OLD STEEL AND PROTECTS NEW STEEL FROM CORROSION · CAN BE OVERCOATED WITH ANY PAINT Directions for use Remove loose paint, rust, oil and grease etc Apply a saturating coat of Penetrol CIP by brush, roller or spray. Where Penetrol CIP has loosened rust, spot prime again. Allow to dry for 24 hours before over-coating. Clean up with Mineral Turpentine. email: info@floodaustralia.com IN AUSTRALIA For more information and assistance with painting problems

© THE FLOOD COMPANY AUSTRALIA. All rights reserved / Designed and managed by Designcom