|
MARINE PENETROL FOR RUST AND METAL PROTECTION
SEE
THE ENORMOUS SPREADING POWER OF MARINE PENETROL
 |
 |
A drop
of conventional metal primer. It has not spread or penetrated,
but ‘bridged’ over the minute pores in the surface
and trapped air and moisture beneath it causing rust in due
course and form those blisters we have all seen. |
 |
The same
amount of paint mixed with 50% Marine Penetrol has spread over
a much larger area and penetrated deep into the surface driving
out air and moisture. |
SEE THE GREAT PENETRATING POWERS OF MARINE PENETROL
 |
This
picture shows the enormous penetrating power of Marine Penetrol.
When it was applied to this heavily rusted joint at Point A
it penetrated between the surfaces of the joint to emerge at
Points B and C protecting the joint from further
corrosion. |
SEE HOW MARINE PENETROL DISPLACES WATER
 |
 |
|
A
drop of Marine Penetrol comes in contact with water. |
|
Marine
Penetrol has crept under the water and isolates it from the
surface. |
MARINE PENETROL MAKES IT EASY TO STOP RUST
 |
This
is how easy it is to use Marine Penetrol. Just saturate the
rusted surface until it has a shiny appearance when it is dry.
Then continue with any good quality oil/alkyd based paint. Where
2-pack paint, epoxy or coal tar coatings are the finish coat,
use Penetrol CIP, the extra tough lead free successor to RLS
which was certified by De Norske Veritas as an anticorrosive
coating for the shipping industry.
THE MAIN THING TO REMEMBER ABOUT TREATING RUST IS THAT IF
YOU CANNOT REACH ALL AREAS OF ALL SURFACES, YOU ARE ULTIMATELY
WASTING YOUR TIME.
IF YOU CAN’T REACH IT - YOU CAN’T FIX IT.
|
MARINE PENETROL MAKES IT EASY TO PREVENT RUST
1. On new steel apply 50/50 mix of Marine Penetrol and a good quality
metal primer. Always buy the best paint available.
2. On slightly rusted (blooming) steel use a 75/25 Marine Penetrol/Primer
or enamel blend.
3. On rusted steel saturate the surface until it is completely shiny
when dry. (Under 2-part paints use Penetrol C.I.P.)
NOTE: Marine Penetrol may loosen rust that is not tightly bonded.
Remove it and repeat step 2.
|
NEW
STEEL
|
LIGHT
RUST
|
HEAVY
RUST
|
|
|
|
|
|
50%
|
|
25%Penetrol
|
|
100%
Penetrol
|
|
Penetrol
|
|
| |
|
| |
|
| MARINE
PENETROL MAKES IT EASY TO REJUVENATE TARNISHED BRASS, COPPER
OR BRONZE |
 |
Rinse
with fresh water and let dry. Scrub with fine steel wool, or
nylon pad and Marine Penetrol to loosen corrosion and tarnish
until the surface is in an acceptable condition, then polish
with a soft cloth. |
| MARINE
PENETROL MAKES IT EASY TO KEEP YOUR DECK FREE FROM RUST MARKS |
 |
Marine
Penetrol stops and prevents rust on anchors and chains and keeps
nasty spots off your deck. For a more pleasing apearance continue
with ready to use Penetrol Aluminium. |
| MARINE
PENETROL MAKES IT EASY TO STOP AND PREVENT SURFACE RUST ON STAINLESS
STEEL |
 |
To
remove rust stains from stainless steel scrub with fine steel
wool or nylon pad and Marine Penetrol, then polish with soft
cloth. An occasional application will keep metal in pristine
condition.
|
|
|
|
|
