MARINE PENETROL FOR FIBREGLASS AND PLASTIC REQUVENATION

MARINE PENETROL MAKES IT EASY TO RESTORE LUSTRE AND COLOUR TO FADED, CHALKY OLD FIBREGLASS
To restore ‘like new’ lustre to dull faded fibreglass or plastics wash the surface first with DEKSWOOD CLEANER (made by Flood) to remove salt, grime and built-up chalk. Wipe off excess water and allow to dry completely. Apply Marine Penetrol by brush or pad and polish with a soft cloth after a few minutes. Treat a small area at a time and do not let the coating thicken. If left too long and the coating thickens apply some more product to soften it and wipe it off.

On some porous surfaces a second treatment may be required until the coating is even and has no ‘streaky’ appearance. After a time, when the coating dulls, repeat the treatment. Practise on a small area first and see how easy it is to rejuvenate your hull without much effort or expense.This owner saved $1000’s by not having to get a costly re-spray. A good clean with Dekswood, a couple of applications of Marine Penetrol and the boat looks like new again.


MARINE PENETROL IT – AND THE COLOUR COMES BACK

HOW DOES IT DO IT?
 Many surfaces, which look dull and lifeless when dry, change their appearance dramatically when wet. They even get their colour back. This is when Marine Penetrol will get exceptional results.All flat exterior surfaces are constantly under attack from the Sun, Rain, Wind and Pollution in the air. Over time they become dull, blunt and porous and uneven (See below). Conventional waxing seals the surface temporarily restoring lustre, mostly with a lot of elbow grease. Marine Penetrol does more. Besides bringing back brilliant lustre it restores colour to dull bleached areas. How? The unique penetrating power of Marine Penetrol lets it go deep into all the microscopic holes and imperfections on the substrate. It will then dry and restore an even surface with a protective seal against the elements. Without much elbow grease.
For economical and easy long term protection use Marine Penetrol on plastics, gelcoat, lacquer, dull paint, chrome, stainless steel and all non-ferrous metals.


© THE FLOOD COMPANY AUSTRALIA. All rights reserved / Designed and managed by Designcom